You can pull the complete tray out of the washer and take it to a sink.
Samsung washer bleach dispenser full of water.
If the dispenser is not dispensing the bleach the most likely cause of the problem is the venturi on this particular washer as water passes through the venturi it should draw the bleach out of the dispenser.
The dispenser should not be full of water.
Sometimes the washer finishes its cycle and leaves the fabric softener compartment full of water.
Check the level of the washer.
Washer initially flushes detergent area left side and fills for wash cycle w o problem.
Why is this happening to such an expensive item we had another samsung washer before this for 10 years and never once did the paint chip rust or become discolored in any way.
I have the lg wm2650hwa washer less than 4 months old.
The fact that the fabric softener has gone and been replaced by water shows that the function has worked.
After using the bleach dispenser remove the dispenser cup and rinse it well or dry it with a paper towel to prevent drips.
If the washer is not level and it is tilting to one side or forward or backward the dispenser cups will not empty completely and you will get drips on the next load.
The dispenser for the bleach is clogged up.
With drawer pulled out after initial fill and wash water enters back of dispenser in a trickle for rinsing never flowing through top right roof section of cavity through holes to drop into fabric softener well.
When i say full i mean that there is water upto the max fill line on the bleach dispenser.
If any is left after the cycle or remains in the drawer the drawer may need cleaning or the washer needs leveling.
The water is left behind due to a blockage or a missing siphon tube.
There will be round circular siphon towers there and you will need to clean them and under the trays there are also the same towers and clean those.
Approximately a tablespoon of water would be normal.
I have looked around bit on this forum for similar questions and the only solutions they.
Over the past month i have noticed bleach dispenser is full of water after a complete cycle.
He3t fabric softener dispenser not working.
Ok so that means your dispenser is working the water when it goes into your bleach dispenser during the cycle is just not going in fast enough to cause it to drain by creating a siphon pressure.
Get shopping advice from experts friends and the community.
The detergent bleach fabric softener and water should flow out of your washing machine s dispenser drawer at the proper time and not immediately.